Happy Holidays to all of our Fabrication Life fans! Always, receiving tons of Tig’d Up Tuesday submissions, we posted a few we felt to show off. Here, we will seperate by date posted. Enjoy the selection and tell us your favorites. We are partial to the flask!
12/17/13
Ariel Banco
“5xxx series sheet. 3mm thickness. 100 amps, no pulse, 2.4mm 5356 filler rod. by Custom Plenum Creations”
Anthony Meyer
“A flower out of 316 with EP”
Ben Ellam
“316 3″ chilled water.”
Derek at SpeedFactory
“RSX strut tower bar/Catch can/Master Cylinder brace combo.”
Samuel Webb
“Rose…”
Danny Steel
“316l stainless steel weldolet welded overhead onto a stainless vessel on a boat at work today. Welded by Angus Irvine”
Alex Lindner
Merge collector to turbine flange weld. Machine set to 130A, 1/16″ 308L filler, standard #12 lens, and a 3/32″ Arctime electrode. I use as much pedal as necessary and constant heat. BP Autosports, LLC.
Brandon Laing
“Necklace pendant. Mild steel wire. 5/16″ and 3/16″ mild steel ball bearings. Black oxide dipped and clear. :)”
12/24/13
Alex Lindner
“2JZ T6 manifold ready to make some power. 304SS schedule piping. BP Autosports, LLC.”
Jeremy Anderson
“304l stainless. .045 rod.”
David B. Normandin
“This is a 308ss helicopter door latch I welded at work on low pwr, 90 amps.”
Cj Morrison
“Evo8/9 hot parts kits. No 16ga runners or flame cut flanges made with Vibrant bends DragNFly Performance LLC”
Brent Bennyhoff
“A few roses I did at work Weldid Designs”
Dustin Gray
“Just thought I would share my aluminum weave with you”
Derek at SpeedFactory
“What do you get the welder beside you? You make him a bad ass flask and throw some super sick dimes down on it!”
